Vertical lattice under deck11/20/2023 ![]() ![]() That would still frame in the raw ends of the lattice (you may have to trim the long side of sheets a bit to get a good look), but allow you to use the bits cut off from the shorter-post end to fill the gaps rather than needing more full sheets. Rather than the cross-shaped framing you have in the middle of your diagram. So, in ASCII where X is lattice and I is frame (II the posts) it would be sort of. Then in the center, use the cut-offs from the shorter end to make a 1'-wide (or thereabouts) 'stripe'. The first thought that comes to mind is to install the sheets vertically, side-by-side. They helped give me ideas of how to attach everything, but not when the gaps are as big as mine are. ![]() Or can they just butt together (I'm thinking no)?Įvery article or video I could find shows examples of really low-to-the-ground decks, which doesn't help much. Also, I will definitely be putting a small frame around each section, but was wondering if I had to have a frame/border where two sheets come together in, say, the middle of a section. I'm willing to frame it like that, if need be, but would appreciate any ideas or possibilities I may be missing. Plus, it seems like a waste of a lot of lattice because the cut-offs will be pretty much useless. The right example looks good and would fill the space, but I would prefer not to spend so much time and money on framing the whole deck out like that. ![]() In the middle example, two horizontally positioned sheets would cover the height, but not the more-than-8ft width. With the leftmost position possibility, the 4' x 8' sheet of lattice is tall enough, but the gap is too wide for two side-by-side. The distance between the posts varies a little, but is approximately 9 feet each. Here is a link to the album that will help you understand my problems: r/DIY now has a Discord channel! Come chat with us!ĭid you miss the AMA with Patrick DiJusto? Click here to read it!Īll content must be DIY - if you paid for the work or found it posted online it is not DIY. AMA with Travis Larson is over Check it out!.COVID-19 DIY PPE Post is live, connecting medical professionals with DIYers!.Quinn Dunki of Blondihacks answers your questions! Read her insights into machining and cat dentistry here. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |